About 25139581

02-21-2025

Hi community,I'm struggling with a flexvpn client I have configured on some remote spoke routers and was wondering if anyone had any better suggestions or alternatives.A typical deployment would see a spoke router connected to a fixed line private ne...

02-25-2025

Hi @Rob Ingram , just to confirm I tested your suggestion today and it works seamlessly. I had to fine tune the sla’s as suggested to reduce the failover.thanks again for your and everyone else’s help regarding this

02-21-2025

Hi @Rob Ingram , thanks for your suggestions.I did think about writing an EEM script that would start / stop the cellular sla's (3 &4) based on the state of track 100.ie. if track 100 is up, then stop cellular sla's 3 & 4, avoiding the flex vpn clien...

02-21-2025

Hi @MHM Cisco World , I've just tested this command 'Connect track 100' then 'Connect track 110' and unfortunately it hasn't made a difference - there is still a 5 min failover time.Thank you for the suggestion

02-21-2025

Hi @MHM Cisco World , thank you for the suggestion. Please can you just clarify what track group should I track - 100 (Fixed line) or 110 (Cellular) Thank you

01-01-2025

Hi @Rayn12345, just came across this post and we're trying to implement something similar, strongswan / linux spoke routers with vti/xfrm interface with the ikev2 tunnels terminating on a cisco flexvpn hub router. We were intending on using Frr to fo...

Member Since	‎07-04-2018 12:58 PM
Date Last Visited	‎03-04-2025 12:41 PM
Posts	6
Total Helpful Votes Received	2

User Statistics

User Activity

Cisco FlexVPN Client query

Re: Cisco FlexVPN Client query

Re: Cisco FlexVPN Client query

Re: Cisco FlexVPN Client query

Re: Cisco FlexVPN Client query

Re: FlexVPN - Virtual-Access - no route to tunnel