Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I recently changed our Asa device from a pix to a new 5510 with 9.1.2 iOS on it. The device has a Vpn tunnel pinned up to our data center where our production servers are. Prior to changing out the Asa, I was able to map a drive to a shared folder on...
I have an ASA 5510 running 9.1(2).
I am not entirely familiar with the ASA firewall, but know enough to be dangerous with it.
What I am looking for is some help on the syntax and proceedure to get a second subnet added into the device and working.
W...
I have an easy question for someone. I am used to the pre-8.3 IOS version of nat'ing and am having some trouble on a newer version nat.What I am wanting to do is port inbound http/https traffic from the outside in and send it to port 5081 on the insi...
I have an old PIX 506e that I am replacing out with an ASA5510, and I'm having some issues on the conversion statements. I have IP Phones that come in from the outside world and get converted to an inside address and a port number ranging from 10021...
All I am in a bind. I have an old 5510 that has version 8.0(3) software on it and I'm updating to a new 5515-x. With the amount of work it is doing I am trying to just script the entries in and do it by hand rather than try to migrate it and risk pro...
This is only happening on the Site-to-Site Tunnel. If I disconnect from the Office ASA and go to the Data Center ASA direct, it will work fine.
No filter that I know of. This is a basic setup for a l2l tunnel and VOIP phone access. Nothing else on it...
Carl,
This is a L2L pinned up tunnel. IT runs from our office to the co-lo data center.
Settings for the tunnel: (tunnel-group, access-list and NAT)
Please advise if all settings are needed.
--------------------
OFFICE(config)# sho run tunnel-group...
Seb,
if you have an e-mail you would be willing to give me, I can give you a sanitized copy of all three configs. Did not want to post them here due to community boards.
-Jon
