Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am setting up a VPN tunnel between two sites and I must be able to pull DHCP addresses across the tunnel to my client devices. At the remote end I have a DSL router in bridged mode connected to a ASA firewall. My client devices are connected to a 3...
I am doing routing on a stick. I have three subinterfaces defined in my router config. Sub1 = 10.10.1.0, Sub2 = 10.10.2.0, Sub3 = 10.10.3.0, and I am trunking between the router and the switch using dot1Q. My question is do I need to have a routing p...
Hello,Here is an excellent document for subinterface limits on a rotuer:http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_tech_note09186a0080094322.shtmlYour 1841 should be able to handle 20 subinterfaces more than adequately.Regards,Ar...
