Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I have a iron port email security gateway placed behind a firewall.Recently i had some latency issue on my firewall because of high traffic going through it, on further investigation i found a large number of drops from iron port going to glob...
Hi, i am running a network having 30 IPS (which indcludes SSM20s, IDSMs and IPS 44XX).i dont have mars device. Is there any way to retrieve events from all the IPS to one central location using csmanager ??or is there any freeware that can do the job...
Hi i have a fwsm running in multiple mode, there are 2 contexts context a and context b. both contexts are running in transparent mode. i have a live communication server(SIP server using standard ports) on the inside on context b and my lan is behin...
Hi,My Internet Module Includes following devices: two cisco 3845, three 3750 one ASA 5540 They are connected as shown in figure (attachment). Both internet routers and switch are meant for redundancy from different ISPs. ASA is having Dmz where mail ...
Hi,What will be the configurations needed to perform a intra-chassis active-active failover between 2 FWSMs, i have done defining the failover and state vlan on switch and also defined it in firewall vlan group.
Hi Andreas,Thanks for your reply. Yes i am using cpt cluster in unicast load sharing mode between. Can you suggest me a solution to reduce these number of drops ? As this is utilising a lot of firewall resource.Regards Manmeet
i tried configuring active/standby config. but the problem i am facing is the same.. when i enable failover on secondary module the failover gets off on primary module. what aould be the reason ?
Thanks for the reply. i tried receiving events with an CA`s snmp receiver but the events i m receiving are not readable .. can u sugggests any receiver.
i have active/active license so cant try active/standby(or can i).i am trying to get a case open in tac but i have to go through procedures(need some time for that).switch is running 12.2(18).yes the switch shows the mac add of blades in apropriate v...
Hi sankar,Thanks a lot for ur reply. i tried the same as u stated above.. but i am coming up with same results. failover group 1 interfeace show normal(waiting) while the interfaces on failover group 2 show unknown(waiting). i think both the modules ...
