About Alex Johnson

Alex Johnson · 02-03-2019

Hello, On my cisco router ( model RV340W ) I have a TV decoder from my internet service provider. It is connected on my cisco router ( LAN4/VLAN3 ). Itself ( cisco router ) connected to my internet service provider router ( by WAN1 and WAN 2 ). Confi...

Alex Johnson · 01-28-2019

Hello! Firstly, my apologies if my topic is on the wrong section of forum. I have create an internal network with my Cisco RV340W. This RV340W is connected at the internet service provider router and distribute the network in my house with some rules...

Alex Johnson · 02-26-2019

Hmmm. You wanna say, I try to connect tv decoder ( VLAN4 ) to my internet service provider ( WAN 2 ) only with static routing rules? and without igmpproxy?

Alex Johnson · 02-26-2019

If I believe the technical specifications of the TV decoder, multicast IP.

Alex Johnson · 02-11-2019

Hmm. The TV flux use RTP protocol. Its a bit strange but maybe...

Alex Johnson · 02-06-2019

The problem, I have try a rules to block all packets. ( All port, all stuff crossing the router, anytime in first position of rules ect .... ). With this rules all my stuff : computer, wifi, smartphone are blocked but the TV decoder no. It is always ...

Alex Johnson · 02-04-2019

When you say "add an access rule above the three existing rules" this rules is ok for you? 192.168.4.xxx -> ANY ( denied service : all traffic, source and destination : all, time : always rules : enabled ) ( replaced WAN2 by ANY and VLAN3 by TV ...

Member Since	‎07-16-2018 09:11 AM
Date Last Visited	‎03-01-2019 02:02 AM
Posts	10

User Statistics

User Activity

Firewall access rules conf and IGMP proxy

Some questions about Wan bridge mode and firewall router on cisco RV340W

Re: Firewall access rules conf and IGMP proxy

Re: Firewall access rules conf and IGMP proxy

Re: Firewall access rules conf and IGMP proxy

Re: Firewall access rules conf and IGMP proxy

Re: Firewall access rules conf and IGMP proxy