Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good Afternoon Could someone just clear up a question for me. On the ATM0 interface on a 877 do you have to configure the bandwidth or will the router automatically negotiate this ? Also is the bandwidth command in relation to the upstream or downst...
Good Morning Could anyone enlighten me on the minimum distance of singlemode fibre between 2 cisco switches using GLC-LH-SM sfp modules before you need to use attenuators. I can fine plenty of information regarding maximum distance but nothing for m...
Morning I currently have a Cisco 887 running Trend filtering which is all running fine and blocking url's etc. I also have a Cisco 2960 and 3 x AP's running behind the 887. I have a VPN running on the 887 to enable us to connect remotely to the devi...
Morning I have a Cisco 887 which is set up with split tunneling, a VPN for remote management and a internal dhcp LAN for general web browsing. My problem is that I can't get telnet to work over the VPN. SSH access works fine but i need to be able to...
Hi CAn anyone help with this..everytimw i try to TFTP a new IOS i get the following error.Loading c870-advipservicesk9-mz.124-9.T.bin from xxx.xx.xx.xx (via Dialer0): !%Tar checksum error in tftp://xxx.xx.xx.xxx/c870-advipservicesk9-mz.124-9.T.binha...
Thanks for the prompt reply, Just to be certain are you saying that attenuators are not required on short runs of fibre?.. I am just concerned about burning out the fibre modules with single mode fibre. Thanks
Some more information, We have 2 vlans configured on the router. Vlan 1 for the seperate users traffic and Vlan 2 for the management traffic we use for the vpn. Vlan 1 is currently the inside zone for the security and dialer 0 is the outside, I have...
