Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I just install ACS 5.3 on a VM.VM Spec: ESX 4.1, 2 CPU, 2GB ram, 100GB HD, 1GB NICAfter installation, when I do "show application status acs", it always show "Application initializing..." after couple hours.I had reboot it couple times, no help.I hav...
I have this command in my configip route 0.0.0.0 0.0.0.0 xxx.xxx.xxx.xxx 1but gateway of last resort was not set, and this route is not show when I do "sho route" command.I try remove it and add it again, no luck.Thank you for your help.
I think you are right.This ASA is not in production. I was just running some test on it. It is not connected to the network.I will try later when I have chance to plug it in the network.Thank you for your help.
