Hi, I need some help regarding ICMP destined to a DMZ host/subnet from the a nonconnected inside subnet. I have 2 PIX 525's at 2 different locations. The subnets know about each other via routing on a pair 6513's at each site. I CAN ping from ...
I am completly in the dark when it comes to appletalk. Can someone tell me if I need to configure the Cable-Range the same on each side of a point-to-point serial connection? Also are there any caviots involved in running VoIP along the same route ...
Hi Everyone, Just had a question regarding PIX DHCP server capabilities. I didn't realize that the PIX even had it first of all. Can someone tell me if PIX (525) can serve addresses to a specific VLAN? I have a small "corporate" VLA...
Hi, I need to know how it is possible to load balance traffic when using BGP between 3 AS's. I didn't think BGP would load balance anything but how would one accomplish this? At least per session/host connection...Thanks,Josh
Hi, Can some one tell me how I should configure my router using frame to pass traffic transparently... I will be using a Cisco 1720 with a dedicated 128k frame on s0/0 connected to a NetScreen (for firewall and VPN) via e0/0. I built the bridge-group...
Nevermind all... i figured it out!I needed a non translated static statement for the subnet I was trying to ping from (the subnet the inside interface of the "far side" firewall sits on).Here is the missing element for reference:static (inside,DMZ-1...
Here is what I have for ICMP access lists and accociated groups:access-list outside-access-in permit icmp any any echo-replyaccess-list outside-access-in permit icmp any any time-exceededaccess-list outside-access-in permit icmp any any unreachableac...
You could also try (if you havn't already):access-list DMZ_whatever permit icmp any any for testing, then dial it in to the host IP instead of any any when you see it working...Oh, and if you havn't already figured it out, be carefull when using the ...
The WAN link is on the inside of both PIX and routed via 6513's on both sides.(When you CAN ping, do you mean you're pinging from one pix to the other?)-Yes(Is this ping from the Pix to the host on the other Pix?)-Yes, but not successful. This is wh...