Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 501 device. I have configured a site 2 site tunnel. It worked for a while (2 days) and then stopped. The problem now is that I'm blocked in Phase 1. My pix send a packet ISAKMP to the other side, the second respond and my pix does nothing wh...
I have a 501 device. I have configured a site 2 site tunnel. It worked for a while (2 days) and then stopped. The problem now is that I'm blocked in Phase 1. My pix send a packet ISAKMP to the other side, the second respond and my pix does nothing wh...
Hi to all, I'm novice in using PIX 501. I want to establish Site to Site IPsec tunnel. I used the PDM (via https) to configure the tunnel. The problem is that I have errors as following :#pkts no sa (send) 22what it means? Any help please. I'm blocke...
Thank you for your help during last days. Finaly, It worked I reset to factory default and reconfigured the vpn Tunnel. Until now, I don't understand the real problem. I'm going to restore my config (access-list, ...) and see where is the problem.T...
Thank you for your help during last days. Finaly, It worked I reset to factory default and reconfigured the vpn Tunnel. Until now, I don't understand the real problem. I'm going to restore my config (access-list, ...) and see where is the problem.T...
I have captured packets between my pix (192.168.99.250) who is nated and the distant gateway (xxx.xxx.xxx.xxx public ip). Is the packets are normal? As you can see, my pix ignore the response of the distant gateway.attaeched s is the debug output.
Thank you. I used this document but no changes. I have changed from 3des to des with the other side and still the same problem. I don't understand why is my pix don't continue phase 1 negociation Any help please?
The second transform set is unused and I have removed it and applied clear isakmp sa & clear cty ipsec sa but no changes. When I make difference between the two peers, I received "NO PROPOSAL CHOOSEN", it's ok. the problem is when the two configs are...
