Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a pix 515 and it is managed through ASDM. My current configuration is very basic. One ouside interface and one inside interface (working in transparent mode). I haaving problems setting up my security policies (rules) to allow outside traff...
I need help with setting up my IP addresses properly. I have the IP for the pix, my DMZ and the only outside IP are the same. I don't want to use NAT's. Can anyone give me clues as to what my addresses should look like through the setup process?
I have on set of ip addresses *.*.*.0 - *.*.*.254. *.*.*.15 is supposed to be the address of my firewall, *.*.*.1 is my default gateway, and *.*.*.7 is my DNS server 1 and my DMZ. On the initial setup, where am I supposed to put these addresses and ...
my configuration is as follows:e0 - outside, sl=0, mtu 1500e1 - inside, sl=100, mtu 1500 (will eventually change to full duplex once system is online live)my security polices are as follows:**any/any inside iterface (ip)...I believe that this is the ...
I have x.x.x.1 through x.x.x.254. x.x.x.15 is the IP of my firewall, x.x.x.7 is my DNS and my DMZ. x.x.x.100 through x.x.x.254 are my personnel IP addresses. Everything up to x.x.x.99 are equipment (email, web, etc.). I am trying to figure out ho...
I appreciate the responses. I do know how to do the configurations...what I don't know is where each of the previously mentioned IP addresses go. For instance what do I put for my internal addresses etc. I know what addresses I need to use but am ...
