Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have one VLAN for customer access to various production and development VLANs.I need to create multiple redundant-vip for each web server farms. Is this possible on CSS11051 using different virtual routers ie.circuit VLAN920vip address 10.10.10.1 2...
I have configured one armed configuration on a CSS11050. I have two web servers 10.1.1.1 and 10.1.1.2 with a vip of 10.1.1.3.If one of the Server services fails or put into maintenance mode, the css will not failover to the existing service. the vip...
I have configured all switches and routing modules with new community strings. however if i do an snmp walk, the interface vlan addresses come up as public. how do i remove the default community strings from the vlan interfaces
CSS11050# sh run!Generated on 01/01/2079 00:00:30!Active version: ap0500063configure!*************************** GLOBAL *************************** persistence reset remap ip route 0.0.0.0 0.0.0.0 168.224.237.4 1 ip route 0.0.0.0 0.0.0.0 10.1.1.1 ...
I bumped the number of servers up to four and this seems to have fixed some of the problems. However when there is only one server remaining in the group(port 80 closed on all other servers), the session seems to hang and never directs the users to...
Thank you for your reply,I have used a network monitoring tool called SNMP sweep by Solarwinds. I added the network addresses to cover the VLAN, and the VLAN Interfaces and HSRP address can back as public.The switch is a 6509 with MSFC. I have config...
The model is a 6509. I have configured snmp at both layer 3 and layer 2. I have used a tool called solarwinds. It picked up the VLAN Interface addresses as cisco default community strings public, which i would like to remove
