Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We set up IPSec between two 2610 routers to connect two private networks addressed 192.168.x.0 and 192.168.y.0. The NAT are not used in our system, and we use proxies for internet accesse. After the following configuration it works fine (the interna...
I have setup IPSec between two routers,and have made debug crypto isakmp,debug crypto ipsec and debug engine commands enabled on both routers. When I use an extended ping from the source router internal interface to the Peer router internal interface...
Thank you for your advice, but it seems the access-list is not the problem. The x in the address192.168.x.0 is not a single value, it include many different values for different vlans, and y in address 192.168.y.0 is a single value. I am sorry I hav...
Hi, wjulia I have the same problem of config an IPSec behind firewall or in DMZ. but I cannot access the site you recommanded. Would you be kind enough to E-mail me a sample configuration? Thank you in advance.Quzhj@sina.com
Yes, I can see some console messages, and I also use the command "term mon" from the remote console port, it dosn't work.I want to see the debugging information is for the following reason.We set up IPSec between two 2610 routers to connect two priva...
