Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,If you have multiple MPLS ISP connected to your network best practice is to use BGO as PE-CE protocol. You can use weight attribute to instruct the traffic the primary path and secondr path. The path with more weight will be the primary and once i...
Hi,No auto-summary does not matter here. It is required only when u are using RIP, EIGRP etc.If it is showing "MPLS required".. cross varify you have enabled mpls ip @ global configuration and @ interface configuration. If u have not enabled it @ int...
Hi,Always try to use EBGP as CE-PE protocol. For ospf problem try using OSPF superbackbone. When you implement this E2 route will appear as inter-area route as PE will work as ABR router.One question:Why you have HSRP adjacency?? Not OSPF or EBGP?? ...
Try using SNMP MIBWALK. If it gives output check NMS configuration. Router will not use global routing table untill you configure route leaking (if interface is configured in VRF).RegardsVikas
Hi,Though question is not very clear, I am replying for what I understood.You can definately implement MPLS, remote end and centeral router must be connected via ISP. Give different RD and RT (based on requirement). Once the data reach to central sit...