Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good day.I have catalyst 6503 with sup720 (2 Gb interfaces and no more additinal modules). At this time I want to configure my switch as border router. I want to configure OSPF, BGP, NetFlow and some policys on interfaces. I have more than 10 externa...
This message just alerting you that someone from ip x.x.x.x trying to connecting to your device via rshell.You can create ACL with...deny tcp any eq 514...statement. In case of PC with x.x.x.x address is in your network you can try to find out any s...
You can try to use parameter "administrative distance":http://cisco.com/en/US/tech/tk365/technologies_tech_note09186a0080094195.shtml#topic2...** If the administrative distance is 255, the router does not believe the source of that route and does not...
Thank you.Possibly my question is not correct. I am understand what is the difference between l2/l3 ports. It is not problem to configuring routing between vlan interfaces or subinterfaces for hw gigabit interface. My question is "which configuration...