Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
When I am tftping the new IOS it suddenly times out, I then see that the static ip address that I set on Gi0 is gone and "ip address dhcp client-id GigabitEthernet0" is back in the interface config. Question is how do I stop this happening so I can c...
Hi all, first timere here. I'm configuring a WLC4400 and am consoled onto it and have given it an ip address, and now I can ping it but I cannot browse to it to complete the configuration.
Thank you Isagabrillo, thats fixed it, for two days I've been struggleing with that!The no-reload command I think was the fixer! thanks againand thanks to Sandeep too
Hi Sandeepdoesnt save config I get..APf866.f244.72b8#wr memBuilding configuration...[OK]NVRAM Verification Failed It just keeps forcing the DHCP config on
Hi Andrew Thanks for the response. I'm not using the service port just the console. I am actually configuring this remotely ( its in Paris ) and I'm in Ireland and there is a laptop consoled into it so getting a xover cable etc would be difficult. ...
