Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I tried to create a PW session between directly connected Cisco7200 routers. I made both routers to act as PE but the VC state did not come up. Now when I insert one P in between the apply the same steps, the VC came up between PEs.My Question ...
Hi,I am trying to configure ATOM between Cisco 7200 routers. But the VC is not coming up. Below is the output:7206#sh mpls l2transport vc detailLocal interface: Fa2/0.1 up, line protocol up, Eth VLAN 12 up Destination address: 5.5.5.5, VC ID: 5555, ...
Hi Marc,I hope the router you have listed are the routers in customer network, isn't ?? Are you configuring the PEs also, or you are planning to take services of some ISP. If you are planning to go with some ISP, then it is pretty simple, all you hav...
Hi Marc,This can definitely work.EoMPLS is the best in this scenario, and for this, Host A and Host B should be connected to router by either FastEthernet or Gigabit ethernet. You may want to define VLAN to keep multiple host (if needed) in different...
Hello Everybody,Finally I succecced in making the PW up. While debugging, I observed that PE was showing the label as "untagged" in "show mpls forwarding" command. So I configured the static binding (implicit-null, label-3) for the adjacent PE as sho...
Hi harold,You are absolutely right that people post their suggestions to help others. And they should not be given low ratings until unless something is really wrong. I missed this fact while rating the mails. Apologies for the inconvenience caused.I...
