Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a point to point T1 from Verizon using a clock source on the one side (uses the standard command: service-module t1 clock source internal). Both routers are 1601R's and they are both running version 12.0(8). We have had these routers in pla...
Thanks so much for the info. I was actually starting to think the same thing. I can't see why my routers would just start "acting up." I'll keep trying with Verizon to see what I can get them to do.
No, unfortunately, I'm not well versed with your instructions. I know enough to create simple configs and run various commands. I have contacted Verizon, and they instructed me to contact them as soon as the circuit goes down again and they will ch...
No problem. I cleared them yesterday morning around 9:00 am Eastern Time. Here they are:CENTRAL LOCATIONfp-hv#show int s1Serial1 is up, line protocol is up Hardware is QUICC Serial (with FT1 CSU/DSU WIC) Internet address is 10.121.0.1/16 MTU 150...
Olufemi, Thank you! Here is my serial output from both ends of the T1.CENTRAL LOCATIONSerial1 is up, line protocol is up Hardware is HD64570 Internet address is 10.21.0.1/16 MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, rely 255/255, load 3/255 ...
