Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
A few days ago, we lost the Ethernet connection to one of our 1310 Bridges. Restarting the unit restored access for a short time. A technician tried to reload the IOS over the console port and set the speed to 115200, and then lost the ability to com...
I am trying to install the Clean Access Server on a Dell PowerEdge 1950, but have run into an issue. The install works just fine, but after the reboot, I get a kernel panic error:Kernel panic - not syncing: Attempted to kill init!Loading mptbase.ko m...
I have a Cisco 1400 Bridge that suddenly lost connectivity the other day. It appears that the bridge is constantly rebooting once it hits a certain point. After about 60 seconds, the status lights all turn orange and another 20 seconds later the devi...
I was finally able to get console access, but I was still getting weird characters on the display. It turns out that the flash was corrupted. I was able to format the flash and reload a working iso image. Thanks for all the replies.
I've tried power cycling it and the lights are still the same. Am I wrong in saying that if the firmware doesn't load, there wouldn't be a webpage to visit?
I was trying to install 4.1.1, but apparently only the PERC 5/i hdd controllers are supported, not the SAS 5/i. Anyone have any clue how I could still get this to work?
