Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Does anyone know how to reset a PIX-515E to its factory default? I've tried "config factory-default", but I get an error saying that the command isn't supported in the 515E. PDM has an option in the file menu, but it seems to give the same command ...
I'm using a PIX 515E firewall to protect two of my servers, with another server in the DMZ acting as a web server. However, I can't seem to communicate between the web server and anything else. I've permitted ICMP traffic for all interfaces, so pin...
Doug, Thanks for the help. I've removed all the routing lines except those from the outer subnets; I'll add those later. However, I still seem to have the same problem. Ping gives me the message "ping: sendto: no route to host" when I try to ping...
One other thing that may help: I've gotten "no route to host" errors while going from the DMZ outwards, and from the outside into the DMZ. Can you see any problems with the routing configuration? "ece-nsl-1" is the outside router.
Doug,Thanks for the help. I'm new to this stuff. Shouldn't communications be working even with no NAT? I've enabled those ICMP functions, but still can't get anything. I've tried SSH in case it was just an ICMP issue, but nothing. Thanks in adva...
