Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I need help configuring a newly reinstated PIX515E with IOS 6.3 to test the configuration of a load balancer.I would like to setup with two Inside interfaces (or simply two interfaces) for testing. I just need it to pass traffic (basically HTTP...
Hello,I am trying to configure two inside interfaces without NAT. I am not using nat-control and I have added exemptions for the two networks. I can communicate between the two networks and to the Internet just fine.I would like to verify that NAT is...
I have an ASA5510 that was working in a HA config that is now constantly rebooting itself. Here is a copy of the dump of traceback messages:Booting system, please wait...CISCO SYSTEMSEmbedded BIOS Version 1.0(11)5 08/28/08 15:11:51.82Low Memory: 631 ...
Jennifer,I tried your suggested config and it doesn't seem to have allowed communications between the two networks or to the Internet. Is there something else that I can try?I also need to make sure there is no NAT. I looked at the Xlate command, but...
Hi Jennifer,Thank you for the reply.Would this accomplish the goal of NO NAT between the two interfaces? Would I need to add exemptions for traffic between the two networks or does that defeat the purpose of adding the command in the first place? I ...
Hi Jennifer,Sorry for the confusion. I do not need the VPN client to connect to the new Inside-test network and did not realize that the changes we added to the inside network would change the status of the VPN client connectivity. I thought the two...
I have tried the suggested config and it breaks RDP from the VPN IP range 192.168.2.0 to the 192.168.3.0 (inside) interface.Also I am not able to test the configuration I need because I am getting an "Inbound TCP connection denied from 192.168.3.45/...
Thank you Jennifer for your responses.Do I need to include access-list commands for both directions for each interface as listed in my full config above, or do I just need one for one direction on one and one direction on the other interface (plus t...
