Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone,i have one router connected to 2 eBGP upstream providers - doing its job for years. After setting up iBGP to a second router (which is not connected to any eBGP yet) I was expecting to see 2 complete routing tables (sh ip bgp all) on rou...
Yes ! That was the problem.Thanks everyone, especially Giuseppe and Ameya.(let me know if I should rate postings or so, I'm not sure about what that accomplishes)
Hi Giuseppe,I use the same prefix list in my route-map (see post), so this filter should already be in effect for my upstreams, right ?So I can just delete the "distribute-list prefix My-Networks out", and the behaviour to my upstreams should not cha...
Hi Giuseppe,on router1 "no sync" has always been in the config and communities are not defined (although I see a neighbour send community statement for UPSTR2)I found another statement on router1: Router bgp 20810...distribute-list prefix My-Networks...
We do have route maps on router1, which is connected to our 2 upstreams, basically the check against an ACL and "beginning with" prefix:route-map TO-UPSTR1 permit 50 match ip address prefix-list My-Networks set metric 0 set local-preference 200route-...
Hi Giuseppe,sh ip bgp summ router1------------------------------------BGP router identifier y.y.y.y, local AS number 123456BGP table version is 104368921, main routing table version 104368921412270 network entries using 48235590 bytes of memory246303...
