Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 2 new T1 circiuts installed for a point to point connection between two offices. I have not worked with a cisco router in quite some time. The topology I have now:Office 1 network = 192.168.100.0Office 2 network = 192.168.200.02*T1 = 3.0Mbps P...
OK, did loopback test on the CSU/DSU units and they are functioning correctly. Also was in contact with my service provider and the private line is working. However, I need to get the demarc extension verified so I will let you know. A cisco enginee...
OK I have removed the PPP Authentication Chap on all serial interfaces. However this did not bring up the serial or multilink1 connections. I also removed the routes I added earlier to see if that would do it and that did not work. Now one thing that...
I configured both routers as presented by hcao asbove, however both are showing down. Is there a command I have to issue to enable multiplexing in a 1841 router? I am also checking with the PTP provider to see if there a configuration that needs to b...
