Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I would like to experiment with different serial links. I would like to practice with frame-relay. I would like to try configuring point-to-multipoint and point-to-point. So I want to have subinterfaces like S0.1 S0.2 and so on. So I guess my questi...
Ok finally I'm successfully pulling in a good dhcp ip address from my service provider. But it doesn't work until i configure NAT. But I have to configure NAT with the ip address of e0 but that's going to be different every day. There has to be a way...
I bought an 8MB flash stick and installed it alongside my original 8MB flash stick, for a grand total of 16MB.But its not working right.On bootup I get this:ERR: Invalid chip id 0x80B5 (reversed = 0x1AD ) detected in System flash% System flash query ...
My topology looks like this:Cox cable internet cloud -> Motorola Cable modem -> [e0] 2501 router [s0] -> [s0] 2501 router [e0] -> 2924 switch -> hostMy mission is get connect to the internet. But its been all fails so far. The e0 port on the 2501 rou...
When shopping for cisco components it would help if i knew what the difference would be when it comes to numbers and letters. At first I thought that the last 2 numbers equaled how many ethernet ports there were, for instance 2924 catalyst switch has...
Beautiful. This is the exact kind of information I seek. There is a lot to this configuration. I'm excited to start on it. As always thanks a lot Michael!
You could also take a look at this post:http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Career%20Certifications&topic=Certifications&CommCmd=MB?cmd=display_location&location=.2cbf0706
There's like 1 or two questions about trunking encapsulation with routers on the test. Like I said you can get by without it.But to successfully set trunking encapsulation, you need a Fast Ethernet or Gigabit Ethernet port, 10Mb/s is never going to l...
Ok after time I have in fact found use for this. But by itself it serves very little use in a topology. You absolutely need another router to do anything. The greatest part of the 2501 is that its SUPER cheap (I only paid $10) and with that you get y...
In my opinion thats enough for CCNA. It would be nice to have 2 switches to play with VTP, but the problem with the 2500 series routers is that they cannot do any trunking encapsulation so you can't set up any usable vlans with them.But the two route...
