Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,My company is currently planning to upgrade our two existing core 6513 switches running CatOS 8.2(1) with two 6509-E switches running IOS (12.2(SXF10a) or later). We utilize a collapsed core design where the 6513's are the STP roots as well as ...
Guys,Attached is a JPG of our STP topology for VLAN6, our NFS VLAN. We are running 2 6500 switches as core devices in each of our 2 Data Centers running PVST. We have noticed saturation on the trunk (labeled "A" in the diagram) between the two Core S...
Sorry to hijack the thread here, but we are experiencing the same issue. TAC has escalated to the development team, but I'm not very optimistic about a fix.We currently have a L5 sticky rule configured with two services bound. Our developers have ins...
You may also want to make sure that the port wasn't inadvertently added to an EtherChannel previously. This can be verified by issuing the command:sho etherchannel summaryYou would also see a channel-group interface configuration command under the in...
Amit,Thanks for the reply. So basically, can it be said that MST reduces the amount of overall BPDUs that get transmitted on a segment? Let's say we have 1000 VLANs and we are sniffing each of the 1000 Broadcast Domains. We will see 1000 BPDUs (one f...
Anees,Thanks for the reply. That is an excellent doc...I had stumbled on it before posting, but missed the Backward Compatibility section which answers my question.What is the most typical place in the network to use as the border for an MST region? ...
I planned on only using it temporarily until the new trunk is forwarding, then remove it. I tested removing it on a link and as expected, it didn't force a re-convergence.Chris