Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I had VSM & VEM setup running, but VM running on VEM have no network connectivity.There are two vmnics on VEM, vmnic0 and vmnic1.vmnic1 is assigned port-profile system-uplink and Virtual NIC on VM is assigned port-profile vmdata103.What could be t...
Hi,There is a command "show tcp statistics" to get tcp statistics.whether this tcp statistics are of VSM or it includes tcp statistics of VSM+VMs on ESX.Thanks,D V
Hi,I want to inspect packets on virtual ethernet of VM.port_group is Port group on cisco 1000v switch.Veth2 is virtual ethernet on virtual machine "esx - w2k3 ent sp2"Module 3 is a ESX where my VM is running.port-profile usage is as follows.port_grou...
Thanks,I checked things you suggested and finally sniffer captured GRE protocol packets.I want to inspect payload packet in that. Can you suggest how can I analyze this GRE packets to analyze network traffic?Is there any GRE protocol analyzer availab...
Hi,Look at result of "show policy-map interface vethernet 3" command.As you can see in bold letters, why some packets are dropped (1522238 bps < 10 mbps)?Global statistics status : enabledVethernet3 Service-policy (qos) input: policy_all poli...
Hi,yes, this is another way we can set bandwidth of virtual interface.But I want to rate-limit icmp traffic to minimize effect of ping flood.For ex., If I assign 10 Mbps bandwidth using this method to veth 4. and rate-limit icmp class traf...
Hi,Output of suggested commands is as follows.Attached file is a snapshot of vCenter switch configuration.n1000v(config)# module vem 3 execute vemcmd show port LTL IfIndex Vlan Bndl SG_ID Pinned_SGID Type Admin State CBL Mode Name 8...
