Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
The setup is in a Lab enviornment with an East and West campus to simulate two buildings, and everything was working fine until we wanted to use AP Group Vlans. Once we configured the AP Group Vlans, updated the AP Templates and pushed them out - it...
Maybe I just got up too early this morning - I have a CAT6506 with WiSM 4.1.171.0 12.2(18)SXF5I put the WiSM in the chassis and it auto created Port Channels 293 & 294, but I can't configure them. This is my first time dealing with Auto Port Channe...
I know in pre-4.x WCS, the coverage maps didn't take into consideration AP's on floors above or below - has this been addressed in 4.2 or 5.x?Also, are the 1131 AP's supported in an upright orientation instead of just the ceiling mount orientation?
We do have a signal when roaming between buildings (in this setup) - where we don't they will be placed in seperate mobility groups.Regarding failover - If we have a WLAN/SSID with a Primary on Cont 1, Secondary on Cont 8 and Tertiary on Cont 16, the...
Before I realized it auto created ports 293/294, I setup Port-Channel 1 & 2 and then on the GigE interfaces I turned channel-mode on for both port-channels and their respective GigE ports.After more configs, saving and reloading the switch, I issued ...
Thanks for the info. The 1131's will be used in the office area's and mounted in an upright position on top of file cabinets. >.<The 1242's will be used in the manufacturing area's.
I have seen similar issues with LEAP (I was using 1231 and 1242 autonomous AP's) - some clients worked, some didn't...clients were all that same OS, patch level, chipset, wireless nic, driver, AP's same IOS, etc.When checking AAA Debugs I would see a...
