Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, folks.I have to set up some VLANS on Cisco 1240 access points. I have a linksys SRW248G4 Switch. I have set VLAN1, as native on the AP, the same as the switch, and added VLAN10 and VLAN20, and associated an SSID with each, The radio interface is ...
Hi, Rob.You have been a fantastic help, I am messing with the access points now following your advice, I can see one SSID now. It might work to put the laptops onto a network with hidden SSID, come to think about it, so that we make sure the remote c...
Yeah, but then guests come with laptops, it's going to be a nightmare trying to get them to join a network they can't see. They are not going to want to start manually configuring, it will annoy them.Not to mention the staff, they are going to hate i...
Thanks, Rob.I have been on that document all day, and others like it... It's really not easy to figure out what to do if you're a newbie.OK, to recap, we set the guest SSID to be the SSID of VLAN10, that means the computers can browse and pick up the...
Hi, Rob,Many thanks for taking the time out to reply.So to sum up, to make this change, we have to configure from the CLI (there's nothing in the GUI to achieve this ?)If I enter this command, then the two SSID's I have set up will now be visible, an...
