About ttroutindy

ttroutindy · 02-03-2010

Does anyone here have experience in creating a port channel with the upstream switch being a Dell PowerConnect 6248? Do I just create a LAG on the 6248? Do I turn LACP on or off? Is there anything special I need to do with the port-channel config bec...

ttroutindy · 02-03-2010

Thank you, that answers my questions.-- Travis

ttroutindy · 02-03-2010

Ok, so the mac-pinning worked perfectly. I am going to be upgrading the firmware on my 6248s that will give me 18 LAGs(Currently get 8 and I have 2 available). Once, I have that setup I will go ahead and setup a LAG for each port-channel. I'm still c...

ttroutindy · 02-03-2010

I do have 2 6248s, however they are stacked. So, I'm assuming it's looked at as one switch and two, correct?Thank you,Travis

ttroutindy · 02-03-2010

I am running 4.0.4.SV1.2. So I just need to figure out the mac-pinning. Does that allow for load balancing in both directions?Thank you,Travis

Member Since	‎02-03-2010 09:54 AM
Date Last Visited	‎07-19-2018 04:25 AM
Posts	5

User Statistics

User Activity

Port Channel & Dell PC6248

Re: Port Channel & Dell PC6248

Re: Port Channel & Dell PC6248

Re: Port Channel & Dell PC6248

Re: Port Channel & Dell PC6248