Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I config mobility group with old architecture between wlc 5520 and 5508and then use mobility anchor Test SSID(anchor)5520(local)------[mobility domain]-----5508(peer to 5520) it is not working I cant get the web redirect for Test SSID 5520 code 8....
I installed wlc 5520(code 8.1.102.0) and add it to Prime version 2.2.0 but it show "not support device cisco"I have problem for step to upgrade Prime infra from 2.2.0 to version 2.2.2 please tell me about the step for upgrade and the require softwar...
I installed wlc 5520(code 8.1.102.0) and add it to Prime version 2.2.0 but it show "not support device cisco"I have problem for step to upgrade Prime infra from 2.2.0 to version 2.2.2 please tell me about the step for upgrade and the require softwar...
Hi Rasika Output from "sh mobility anchor wlan"==5520==(Cisco Controller) >show mobility anchor wlan 1Mobility Anchor Export List Priority number, 1=Highest priority and 3=Lowest priority(default). WLAN ID IP Address Status ------- ...
Hi Rasika This is output from both WLC below ===5520===New Mobility (Converged Access).................. EnabledMobility Protocol Port........................... 16666Default Mobility Domain.......................... BU-WiFiMulticast Mode ..............
