Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Mike,Have you tried to change the logging level on the wlc? There are multiple levels of logging that can be set on the wlc. On the wlc GUI, you can check the current logging level by navigating to this page - Management > Logs > Config > Syslog Serv...
Hi Bryn,If the APs are all connected to the controller and you have a WCS, it is easy to push telnet/ssh config to all the aps at one go. On the WCS, create an ap template, enable telnet/ssh access and apply to this template to all the aps that you w...
Hi,Are all the access points configured to be in the same BGN? How many access points are configured as root? Sometimes, if a mesh access point can hear from multiple parent aps, it might cause an issue.Regards,Nagendra
Hi Vincent,What camera is this? Have you configured a static ip on your camera? How long have you waited after the fail over before you determined that the camera would not work?Regards,Nagendra
