Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I setup a network for testing multicast streaming.It is a non routing environment for unicast, but it is success in multicast.I check that the multicast source is not present in unicast routing table, how it pass the RPF checking??on the other word, ...
Hi Anthony,I have borrow the equipment again and retry the lab, the multicast traffic is success but rpf check is fail in the 1841 router.I have capture some information (config, routing table, mroute, igmp group, pim and rpf check) in the lab. Is th...
The routing table of the router:For Cisco 2811:C 10.0.0.0/8 is directly connected, FastEthernet0/0C 172.16.0.0/16 is directly connected, FastEthernet0/1For Cisco 1841:C 192.168.1.0/24 is directly connected, FastEthernet0/0...
I didn't issue the "no ip routing" command and I know the connected routing entry, so I use two router in the test. For the details, you can found my reply on the previous.
The above is my network diagram.Since my router is aleady return to others, I can only tell what configuration on each router.Cisco 1841:ip multicast-routinginterface f0/0ip address 192.168.1.1 255.255.255.0ip pim sparse-modeip igmp version 3interfa...
