Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
In your case, you should configure the session timeout value in RADIUS no less than 24hrs.Disable DCD will only made Meraki that not revoke the client in Meraki end.With DCD enable + client session does not expire:Endpoint re-associate after power sa...
It should depends on what method that you choose for the authentication and the session expires or not.If the session does not expires, there is no re-authentication requirement.So, the client endpoint re-associate to the SSID within 2-3 sec.Otherwis...
DCD feature is under the Meraki Dashboad > Wireless > Access control.For my environment, association requirements are open and splash page is using "Sign-on with my RADIUS".L2 & L3 settingDCD feature
I have talked with Meraki today, find out that this issue is caused by DCD enabled.If you don't want the user to re-authentication again, you can find a function named "Enable data-carrier detect?" under the access control page. Disable it and will b...
