Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a PIX 501 that I am setting up at a site that has one static ip address and a router. I have never setup a PIX 501 without a public address on the WAN so this is new to me. I have assigned the outside interface of the pix to 192.168.0.254. ...
I have setup two pix 501 running OS version 6.3(5) with a 10 user license between two offices conencted via DSL. Traffic flows both ways as intended. However, occasionaly I have a problem where I cannot remote onto any machine at the remote office ...
Recently our company has purchased a new ethernet capable time clock system. I've read the manual concering the time clock software and tested in a lab environment using a laptop and small switch, which works fine. However, upon real implementation...
I am trying to setup a PIX 501 so that remote users can dial in to access then network. I used a sample config to create my current config and would like anyone to point out errors or make suggestions. I have attached my config. I would appreciate...
Ok I got one tunnel to work fine (192.168.8.0 to 192.168.1.0). ICMP and data traverse thetunnel. However I cannot seem to get the other tunnel working (192.168.5.0 to 192.168.1.0). If I do a sh crypto ipsec sa on both sides I can see the encapsula...
Well I received my unlimited user license for the main PIX and the 50 user license for one of the remote offices. I added the activation key and everything went according to plan. I notice when I do a sh ver that it shows IKE peers is 10. Is this ...
At the main office I count 1 outside ip address and 14 inside. At the remote office I count 1 outside and 10 inside. Does this mean I need to buy 50 license upgrade for both locations? Thanks again...
