Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi. I have such of configuration R1(Gre/Ipsec) --> Pix ( Ipsec) - R2 ( Gre).On my side is only R1. I've attached the R1 CONFIGURATION. Ipsec is up but GRE is not . I can not ping the loopback interfaces. Keepalive is fine and when i debug the tunnel ...
Hi. I want to create a ipsec vpn between 2611 and pix ( pix is not on my side ). I have this configuration on 2611.crypto isakmp policy 10 encr aes 256 authentication pre-share group 2crypto isakmp key xxxxxxxxxx address y.y.y.y!!crypto ipsec transfo...
I've created an ipsec between two Pix515E. One interface of Pix1 is nated in public ip address from the outside router R1. In pix1 interface VPN i have placed the router R2 for creating the GRE. Ipsec is up but GRE is down. On the other side is Pix2 ...
I have only the router on my side. The pix and the other router for ending the GRE are on their property. At this moment they aren't avaible. At my router the ip address of their loopback for GRE should be routed at my external gateway or at their ex...
Unfortunately they can't give me the schema of connection between their router and Pix. I have only some data of the Gre and ipsec their configuration. Here they are:Router:interface Loopback17 ip address 192.168.5.22 255.255.255.255 no ip redirects ...
Unfortunately no. But they say that they have 35 clients and they've run the configurations properly. I've seen a lot of configurations with GRE/IPSEC and all were like this one ( i've configured ). I don't know what else to do. Let's say that now i'...
Hi AndrewHave a look to the schema. R2(GRE)-> Pix1(IpSec) -> R1 (Nat) -- /\Internet\/ -- Pix2(Ipsec) -> R3 (GRE). The private ip add of Pix1 is nated from R1 to the public ip add. But i can not receive any request for ESP . I receive only for udp500 ...
