Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to get a site to site VPN established from a PIX520. There is only one outside interface IP and NAT is setup on the PIX. The NAT works fine for general web/email etc and all inside hosts connect to websites reporting their IP as the outsi...
I am tring to forward 2 ranges of ports from my outside interface ip to a host on the inside interface. The outside interface is natted so that all inside hosts use it's single IP for general use.I have 2 ranges, 5096 - 5099 and 17300 - 17440 to forw...
I can ping stuff on the internet from a host on the inside now anyway. I can happily ping www.google.com and get the replies back with now problems. it's just hosts over the VPN i can't get too. Pinging www.google.com I get :U:\>ping www.google.comPi...
Hi,I don't seem to be getting any usefull info from the PIX logs excpt that when the tunnel is up, if I ping the remote end I can see 1 packet going out and one packet coming in.Also wouldn't the fact that if I ping from the PIX cli and I get the res...
OK Thanks. That will be my task for the morning. I'm still not convinced that the 3rd party at the remote end are sending it back to but I have no way of confirming it except to ask them and they say they are. I will try and setup the logging on the ...
It's OK - this time it's just me. I did the cut and paste above after I had tried changing the default route for tsclients to point to it's vlan IP ( clutching a straws basically ! ). It made no difference and it's now back to 10.192.10.1 .... but st...
Sorry - I probably removed more of the PIX config than I should have when I sent it the first time.There is an inside route setup. We have 2 sections. one is :name 10.192.20.62 marshal2name 192.168.0.0 tsclientsname 192.168.10.0 tswirelessand the sec...
