Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a Cisco 5520 with the ASA-SSM-10 IPS Module. I am running version 6.1(2)E3. I need a way to whitelist an IP Address from a Security Scanning vendor. The vendor is Control Scan and everytime they try to certify our site it fails because the IPS...
I have been running a L2TP over IPSEC VPN for awhile now with no problems. For some reason it mysteriously stopped working at 6:45pm CST yesterday. Posted below is the debug log for crypto isakmp and ipsec. Attached is the debug output. 71.40.x.x is ...
I am having trouble with connectivity and the IPS Module. The IPS management interface is plugged into a dell powerconnect switch using a straight cable and it shows a link. However I cannot ping the ip address i have assigned the management interfac...
Is there a way to use the Windows Native VPN Clients in conjunction with ASA 5520's running IOS 8.0? XP and Vista. I would rather use them because I have several custom applcations that are triggering the windows VPN Client. As a workaround I have j...
This is what i see when i run that command.asa1# sh running-config tunnel-group DefaultRAGrouptunnel-group DefaultRAGroup general-attributes address-pool vpnpool default-group-policy DefaultRAGrouptunnel-group DefaultRAGroup ipsec-attributes pre-shar...
I am doing local authentication.Will it do LOCAL authenticationby default. I went to double checkand noticed that nder the tunnel-group general attributes there was no authentication methid specified. When I tried to specify it again using the authen...
I issued the show module 1 details command and everything shows up. I looked at the switch and everything is in the up state. I have tried pinging from the IPS to nodes on the same leg but nothing is going through. Im looking through the link you pro...
