Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Everyone,
I have a single 3802i with Mobility Express 8.5.131.0 running and whenever I set the 5ghz channel to 160mhz the cleanair status for that radio goes to admin enabled but status down. I've tried this on 8.7 with the same problem. Clea...
I don't see a way to configure the second radio as monitor mode in Mobility Express i don't think that is supported. If i configure the first radio as 160mhz cleanair works fine.
I currently have 2 160mhz channels to choose from. Either way I only need 1 right now. I'm not worried about overlap. That's not the issue at hand. I think practicality is for another discussion.
There aren't many devices that support 160mhz as yet but for my purposes it is practical. The product specs state that cleanair should work on the 160mhz band so i'm trying to determine why its not working.
