Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
1) What does the middle number [1] stand for on interface gigabit2/1/2?2) On 'show mac table command', what does Po11 stand for?3) The 'show mac address-table' command displays “Total Mac Addresses for this criterion: 492”, On [2 x] stacked WS-3850-4...
Our Internet access is connected to a Nexus 9500 switch. Internet traffic is passed through the Nexus to a none-Cisco firewall [master/slave fail-over] for filtering. Data is filtered by the firewall back to the L3 switch for routing to destination...
Peter, Thanks for your reply. The majority of gigabit ports on the switch has "0" in the middle of the port interface number. I have seen a few port interfaces on the 3850 that have numbers other than a 0.