Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good afternoon everyone,
I have a Cisco 3850 (WS-C3850-48P) with a wireless controller licensed:
The AP's connect with the controller but never start broadcasting, on the AP the following information appears them both radios state gets set as down:
...
After the console log from previous post it repeats:
*Sep 6 18:29:28.000: %CAPWAP-5-DTLSREQSEND: DTLS connection request sent peer_ip: 10.10.17.253 peer_port: 5246*Sep 6 18:29:28.287: %CAPWAP-5-DTLSREQSUCC: DTLS connection created sucessfully peer_...
Hi Sandeep,
Yes Radio is enabled on the Wlc side, below are the complete logs from AP console.
Thank you very much for the support
Best Regards
IOS Bootloader - Starting system.flash is writableAntigua Board40MB formatTide XL MB - 40MB of flashX...
Hi Sandeep,
Thank you for the fast reply, answers below:
1. make sure your 3850 is configured as MC in order to act as WLC functionality.
-Configured as MC
2. Make sure you APs are connected directly to 3850.
-Connected Directly
3. If wlan ID number...
