Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
An interesting issue came up for me. I have an ACL that allowed host A to Host B on port 636. The firewall have a tcp session timeout of 2 hours. Host A established a sesson with B did some transfer and went idle. It then tried to send data aga...
Hi everyone, I am doing posture checking with AnyConnect. 1 of the check is to check the value of a Windows registry key. The remediation action for this requirement is set to "Message text only" Posture works and will pop up a windows with the pre...
Need some ideas on how to load balancing setup. I have 2 routers, each with a layer GE WAN connection and receives eigrp routes. The routers also have a layer 3 connection between them and are exchanging eigrp. I want to have traffic reach rout...
Is there a way I can have 2 ports, say gi 0/0 and gi 0/1 on the same segment on the 5585? Obviously, 1 of the interface will have an IP address while the other will not. This is similar to interface vlan xx and assigning vlan to a port in the 5505....
@Seth Beauchamp wrote:I would think you could use an offset list on router 1 in increase the metric of some subnets so that metrics are better from router 2. How did you have this configured?Are you getting a default route from these WAN connections?...
@Seth Beauchamp wrote:I would think you could use an offset list on router 1 in increase the metric of some subnets so that metrics are better from router 2. How did you have this configured?Are you getting a default route from these WAN connections?...
Well, I have 30 ports on the firewall and only a couple was used. So I have plenty of ports. The devices that need to connect to firewall are in the next cabinet, while the switch is in a rack 2 rows away.
