Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi.I have main_office1 and main_office 2. My DNA border switches located on main_office1.Edge switches of main_office1 connect to border node 1 and bordernode 2 . and works fine.I connect new device (main_office_2_intermediate_node) that same model o...
@Boort . Yes connectivity has.i was using 9500 as intermediate device. i checked license on dna center. 9500 is overuse. so i try tested with other model (9300) that are license is ok.But i have other problem with lan automation. I have tested 2 devi...
i don't understand you. I factory reset switch and check, result is same. I used pnpa service reset command over console and check, result is same. I wanna automated edge switches over intermediate node ( intermediate node as seed device). But lan ou...
edge device (that connected to intermediate node) was resetted. (with pnpa service reset command ).lan_outomation pool was selected during start lan outamoation. If it have problem on pool, i must couldnot automated other devices(taht directly connec...
yes,I can automated intermediate node ( seed device is Border node)i will try automated edge (that connect physically to intermediate) (seed device is intermidiate node) but nothing happen
