Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I'm trying to find out if it's possible to use an ASA to route traffic primarily (in clear text) via an MPLS link (on a dedicated interface) and, in the event of failure of that link, failover to a internet based VPN.I'm aware that we can use tra...
Hi, I'm trying to configure a VPN between a Check Point firewall (UTM-1, running R75.10) and a 2921 router (15.0(1r)M9).Here's the relevant config (names and external IP addresses only modified - using 1.1.1.1 for Check Point and 2.2.2.2 for Cisco):=...
In case anyone is interested, I found the cause of this problem. The engineer that built the client VPN configuration for this device configured it to initiate ip client configuration as well as respond.Removed the "crypto map mapname client configu...
I've fixed some issues with the route map configuration (this is part of a larger project, all others are working), so at least I'm now comfortable with the NAT.Would definitely appreciate it if someone could shine a light on how to replicate the fu...
Thanks, unfortunately the "no-config-mode" doesn't seem to have survived in the new IOS version.As you say this isn't something I would usually expect to have issues with. My only slight concern is that I've done something wrong with the NAT, but it ...
