About brian-jamieson

brian-jamieson · 01-25-2015

We have a CISCO RV130W setup as an IPSEC VPN server that we can connect to using the ShrewSoft client. Once connected there is no issue in pinging the router. DHCP on the router is set as a relay to our internal DHCP server which has a scope assign...

brian-jamieson · 12-17-2014

We recently purchased 2 RV130W routers and I did not have any issues setting up a site-to-site VPN IPSec tunnel between 192.168.xxx.0 and 192.168.yyy.0 Now on one of the routers (192.168.xxx.1) I wish to setup the IPSec client server section so rem...

brian-jamieson · 01-30-2015

Thank you for your comments Kremena1) The RV130 is the gateway for LAN users2) The Shrew config Policy Generation Level is 'Required', both checkboxes are not checked, and our LAN subnet and mask is correctly entered. I can establish a VPN Shrew conn...

brian-jamieson · 12-27-2014

Thanks for your input Michael. I think we'll be trying Shrewsoft or perhaps a paid solution such as Greenbow.Brian

brian-jamieson · 12-27-2014

Thank you for your information Mehdi. The PDF and link to ShrewSoft is very helpful.Brian

brian-jamieson · 12-23-2014

Thank you Mehdi ..that worked well. I can now run a site-to-site tunnel and also the IPsec client-to-site.Another related issue is with the Cisco IPsec VPN client version 5.0.07.0440. In the Client interface in the Authentication tab it asks for a N...

Member Since	‎12-17-2014 08:17 PM
Date Last Visited	‎11-09-2020 07:31 AM
Posts	6

User Statistics

User Activity

IPSEC VPN client cannot ping internal LAN devices and not getting IP address assigned by DHCP server.

RV130W VPN router IPSec server setup

Thank you for your comments

Thanks for your input Michael

Thank you for your

Thank you Mehdi ..that worked