Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,We have a 3750 and trying to add a /48 to ip route, it accepts the command but it does not work or work as a gateway, it does work as a /64 though.We are running the following12.2(55)SE12 C3750-IPSERVICESK9-MIs there anything i can do to make i...
Hello, We are trying to setup a /48 IPv6 in our 3750 but doesnt seem to like it and doesnt pass it and stops it all pinging and working on the internet but works internally for some strange reason. Any ideas? i have asked our uplink supplier to check...
Hello. I am having some issues with OSPFv3 and BGP and loopbacks We have an active active connection on BGP some traffic goes in on one switch and out on another depending on route.. But the issue is its not traveling back through link connected betw...
Hello, I am trying to run Ipv6 via our network but the cisco 3750 vlan has a local link and is showing up as a gateway on the a connected client on that vlan. can i stop the link-local fe80 ipv6 ip's from being enabled on the vlan and showing up as a...
Hello. We have setup a IPv6 IP on a vLan which we use as a gateway for our pfsense but the issue is that the ipv6 on the vlan is advertising IP's which we want to disable. I have tried a few different things but with no luck. Can anyone give any advi...
I said the same and they need to use the gateway from their /64 subnet.They want to give each of their clients a /64, they explained if they get banned from google they block the /64 and not a /48 so one client would not impact another. Also another ...
I 100% agree, its what our client wants, and im just trying to make it work. their idea is to have multiple /64's for clients and point them to /48 gateway
I dont have that optiononly thesemetric Metric for redistributed routesmetric-type OSPF/IS-IS exterior metric type for redistributed routesroute-map Route map referencetag Set tag for routes redistributed into OSPF
Hello,So im thinking its an issue with the ospf v3I have the following set on the vlanipv6 address 2A03:F80:99::1/48and OSFv3ipv6 router ospf 2000
router-id 4.4.4.4
log-adjacency-changes
area 0 range 2A03:F80:99::/48
default-metric 25
redistribu...
sorry for the confusion, yes at first we tried it as a vlan to see if that was the issue, but now we are trying it as a static route which is having the same issues.
