Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys,My router is Cisco 2811 with IOS version 12.4(22)T1. It had established IPSec with another peer (203.*.*.250 shown below) for long until recently we make it re-establish IPSec VPN with another peer (203.*.*.30 shown below). It showed that the...
Hi Guys,I have a question in regards to route redistriubtion. For example:Router A has enabled BGP and EIGRP, and its EIGRP neighbour is Router B. Now Router A redistriubte BGP learned route to EIGRP process, Say, one of the BGP learned route is call...
Hi guys,Just a bit confusion here. I know from Cisco documentation, per-packet load balancing is only enabled via CEF. But while I am doing labs in GNS3, I think I have enabled per-packet load sharing and at the same time disabled CEF, which means fa...
Hi John,It turned out that the firewall has an policy which contains incorrect subnet (where the router is). And it is fixed. Thank you very much for your help!Regards,Alex
Hi John,I am pretty sure the ip addresses are correct. When I issue the command show crypto session, the result looks like this.# sh crypto sessionCrypto session current statusInterface: Cellular0/3/0Session status: DOWNPeer: 203.*.*.30 port 500 IP...
Hi John,Here is a portion of the debugging info:643931: Jul 17 06:41:06.744: ISAKMP:(0): vendor ID is NAT-T v2643932: Jul 17 06:41:06.744: ISAKMP:(0): processing vendor id payload643933: Jul 17 06:41:06.744: ISAKMP:(0): vendor ID seems Unity/DPD but ...
Hi John,I tried your suggestion but with no luck:crypto map VPN 10 ipsec-isakmp set peer 203.176.96.30 set transform-set ESP_3DES_SHA match address 106I created a new ACL 106 and its definition followed yours:access-list 106 permit ip 192.168.21.0 0...
