Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have just purchased a 1242AG and I am trying to configure it. In the web interface, when information is entered in the express setup and express security screens, and I "apply" it, nothing is saved. Is there something obvious that I am missing?Tha...
We have just purchased a 1242AG and I am trying to configure it. In the web interface, when information is entered in the express setup and express security screens, and I "apply" it, nothing is saved. Is there something obvious that I am missing?Tha...
Ok, I have made headway. Using a combination of the web interface and the CLI, I have the 1242AG partially configured. My question now is in the CLI how does one turn on broadcasting of the SSID so clients can see it?
The part number is AIR-AP1242AG-A-K9. And I believe it's the autonomous version but how do I tell for sure? The web interface to the unit shows system software as: c1240-k9w7-tar.124-10b.jA with a version of 12.4(10b)jA
I tried that:ap>en% Error in authenticationWhat I am trying to do is setup a very basic 2.4GHz access point with WEP 128bit encryption and accepting only a very short list of MAC addresses. I would think this would take a config of only a few lines. ...
