Hi,Please check if you have tcp port 10000 open at the perimeter router also check if crypto-ipsec-over-tcp 10000 is enabled at the remote end.regards,Nitin
Hi,I understand that you need to create a tunnel between ASA 1 and ASA 2 withe one ISP and the other tunnel on ASA 2 with other ISP on ASA 2.It is possible provided that you take care of the routing. For remote access clients it will terminate on the...
Hi,Yes it is possible for pix to have two interfaces with two ISPs. Also the 501s can connect to the old ip address on pix. but there are two situations:1) If Pix 501s has static ip address and the default gateway to the new ip address then you have ...
Hi,yes it is possible. Please check the following document.http://cisco.com/en/US/products/ps6120/products_configuration_example09186a00805733df.shtmlIn this example the other end is a Pix. However on ASA with dynamic ip address you need to configure...