Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I was wondering if anyone could point me into the right direction in setting up a multihomed environment to 2 ISPs via multiple local routers using OSPF / BGP ???Any config examples would be much appreciated.This is the scnario:ISP A ISP B ^...
I have 2 CSS 11152 and I would like to set them up to load balanced between each other (no the box to box redundancy failover). Would the DNS proximity setup be possible in a single location ? If not, how can I achieve this ?Thaks in advance,Leonel
I have a scenerio where we have a network with a single Internet connection.I have a Cisco router on the Edge running FULL BGP (yes, I know, ... not wise but soon enough will be implementing a secondary connection to a different ISP).At the moment I ...
Well, I am new to OSPF ... so any cofig examples that fall within my requirements will help.The diagram that I published before didn't come up the way I want it, ...so here it comes the 'written' vesion:The 4 routers live in a fully meshed environmen...
Thanks for you reply Jeff, ... I have seen this doco, I have the BGP setup pretty much under my belt my the OSPF routing is what I am the most interested at this moment, in particular to do with edge routing, boarder routing.Cheers,
Tony, there is a pretty good doco on 'fault taulerance'.Please check it out and let us know if it is what you were looking for.http://www.cisco.com/warp/public/117/box_to_box_redundancy.html*To set up a load balance solution would be a bit more compl...
Hi David,I don't see anything wrong with your theory, in fact we run a similar scenario using a scripted XML test in the page that is tested by the CSS.As you know the CSS has the ability to checksum (GET method) a Web page that is retrieved over HTT...
We did notice it .... we are running 5.0008s and it's a NO go. We found that out the hard way .... on a deployment so we didn't get a chance to review, troubleshoot ..... and the likes so we ended up just using the 'no persistent' with the 'primaryso...
