Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, I have a CCM 6.1 and a ccm 4.2 both are connected to a normal switch. there are two ip phones registered with each of the call managers and calls can be made between any two phones registered with the same call manager. i wanted to set up a s...
HI all,I have a strange issue... i have an ip phone connected to a switch this ip phone is reghistered with a call manager 6.2. now for soe reason the phone kepps on restarting after every 5 mins. also i can see that the extension number on the phone...
Hi all,I have a CCM 6.1 and a ccm 4.2 both are connected to a normal switch. there are two ip phones registered with each of the call managers and calls can be made between any two phones registered with the same call manager. i wanted to set up a sc...
HiI have a CME 2801 which in y lab which has 3 ip phones connected to it. the settings are configured and i can make calls between the three phones. now i tried to upgrade my IOS from (C2801-SPSERVICESK9-M), Version 12.3(11)XL, to SPSERVICESK9-M), Ve...
Hi,i have a CME 2801 router. It has 2 FXS ports and Two FXO ports... if i want to configure these ports how do i do it. in other words if i have to assign an ip address to an ethernet port on my 2801 i give the command int fastethernet 0/1 and then ...
i tried to configure the route groups and patterns but i am not able to make calls... i m not sure if i have done everythin correctly or may be theres somethin else i need to do.. plz suggest
Also i would like to add... this is not a huge set up it is just a small lab... there is no possibility of a network outage or any thing like tat... and i am fairly new to this so i really would appreciate you help
