Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
I'm planning an upgrade of a Cisco 9500 stacked pair and noticed that the boot system shows 'Boot Variables on next reload' = 'BOOT variable does not exist' on Switch 2 (see below), should I be worried?
Ive tried deleting and re-adding the bo...
Hi All,
Ive started an upgrade program of C2960 (X/XR) switches but recently faced an issue where some / most STACKED switches fail to take the new image 152.7.(E7) and instead revert back to a historical image left in flash, presumably the first .bi...
Ive upgraded an ISR4451 (previously configured with a number of IP SLA probes) to 17.6.3 but since the upgrade the IP SLA GROUP SCHEDULE line of code has been removed from the configuration. When I try to re add;
HOSTNAME(config)# ip sla group-schedu...
FIXED! It appears that the group schedule doesn't like non contiguous entries! Used (config)#ip sla group schedule 1 and added smaller contiguous blocks and its taken that.
There is no IP SLA GROUP SCHEDULE in the running configuration but this is what I'm trying to input;
(config)#ip sla group schedule 1 100-1835 schedule-period 300 frequency 300 start-time now life forever
Hi MHM Cisco World, Ive tried changing the schedule number to a few options but each time the CLI returns - (%Grp Scheduler: operations are not configured)
